Black & Decker PHV1410 Instruction Manual download pdf (Page 3)

• Shock Hazard. To protect against risk of electrical shock, do not put unit or charging base in

water or other liquid.

• Do not allow the cord to hang over the edge of a table or counter or touch hot surfaces. The unit

should be placed or mounted away from sinks and hot surfaces.

• Plug the charger directly into an electrical outlet.

• Use the charger only in a standard electrical outlet (120V/60Hz).

• Unplug the charger from outlet before any routine cleaning or maintenance.

• This product includes rechargeable nickel cadmium batteries. Do not incinerate batteries as they

will explode at high temperatures.

• Leaks from battery cells can occur under extreme conditions. If the liquid, which is a

20-35% solution of potassium hydroxide, gets on the skin (1) wash quickly with soap and water or

(2) neutralize with a mild acid such as lemon juice or vinegar. If the liquid gets into the eyes, flush

them immediately with clean water for a minimum of 10 minutes. Seek medical attention.

• Do not look into the air vents when the unit is switched on, as sometimes

there is a possibility of small debris being discharged from the air vents, especially after cleaning

/ replacement of the filters as debris inside the unit can be disturbed.

SAVE THESE INSTRUCTIONS

Symbols

• The label on your tool may include the following symbols. The symbols and their

definitions are as follows:

V ..................volts A ................... amperes

Hz ................hertz W ..................watts

min ..............minutes

or AC .......alternating current

or DC ..direct current

o .................no load speed

................Class I Construction .................earthing terminal

(grounded)

................safety alert symbol

................Class II Construction .../min or rpm ........ revolutions or reciprocation

(double insulated) per minute

• When using an extension cord, be sure to use one heavy enough to carry the current

your product will draw. An undersized cord will cause a drop in line voltage resulting

in loss of power and overheating. The following table shows the correct size to use

depending on cord length and nameplate ampere rating. If in doubt, use the next heavier

gauge. The smaller the gauge number, the heavier the cord.

Minimum Gauge for Cord Sets

Volts Total Length of Cord in Feet

120V 0-25 26-50 51-100 101-150

(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

240V 0-50 51-100 101-200 201-300

(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)

Ampere Rating

More Not more American Wire Gauge

Than Than

0 - 6 18 16 16 14

6 - 10 18 16 14 12

10 - 12 16 16 14 12

12 - 16 14 12 Not Recommended

1 2 3 4 5 6 7 8 ... 27 28

Comments to this Manuals

No comments

Black & Decker PHV1410 Instruction Manual Page 3

Comments to this Manuals

Related products and manuals for Battery chargers Black & Decker PHV1410