u Do not store in locations where the temperature may
exceed 40 °C.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u Charge only using the charger provided with the
appliance/tool. Using the wrong charger could result in an
electric shock or overheating of the battery.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
u Do not damage/deform the battery either by puncture or
impact, as this may create a risk of injury and fire.
u Do not charge damaged batteries.
u Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries carefully wipe the
liquid off using a cloth. Avoid skin contact.
u In case of skin or eye contact, follow the instructions below.
Warning! The battery uid may cause personal injury or
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a specic voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
u Use your Black & Decker charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
u Never attempt to charge non-rechargeable batteries.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/tool/battery must be placed in a well
ventilated area when charging.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
-
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
Charge only at ambient temperatures between
10 °C and 40 °C.
y
Charging
Electrical safety
#
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains voltage
corresponds to the voltage on the rating plate.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
u Warning! Never attempt to replace the charger unit with a
regular mains plug.
Features
1. On/off switch
2. Forward/reverse slider
3. Forward/reverse window
4. Bit holder
5. LED light
6. Mode selector / torque adjustment collar
7. Screw holder
Fig. A
8. Charger
9. Charging base
10. Charging indicator
11. Bit storage
Assembly
Fitting the charging base to the wall (g. A & B)
The charging base (9) can be placed on a worktop or tted to
the wall to provide a convenient storage and charging point for
the tool. Screws and wall anchors are not included.
u Drive screws in the wall with the same distance apart as
the slots (13) on the back of the charging base (9).
The distance between the slots must be 75 mm.
u Slide the charging base over the screws to fit the base to
the wall.
u Plug in the charger (8).
u Place the tool on the charging base making sure the
charging indicator (10) lights up.
Warning! Avoid damaging the power cord when mounting the
charging base to the wall.
(8 pages)
(38 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals