Black & Decker Fire Storm 90524442 Instruction Manual download pdf (Page 30)

FASTENING THE MACHINE TO A SUPPORTING SURFACE

Before operating your compound miter saw, make sure that it is firmly

mounted to a sturdy workbench or other supporting surface. Four

holes are provided, two of which are shown at (A) Fig. 8.

When frequently moving the saw from place to place, mount the saw

on a 3/4 in. piece of plywood, and clamp the plywood to a supporting

surface with “C” clamps.

OPERATIONAL CONTROLS AND ADJUSTMENTS

TABLE HAZARD AREA

WARNING: The area inside the two red lines on the table

(A) Fig. 9 is designated as a "hazard zone". Never place your

hands inside this area while the machine is running. Maintain

hands 6 in. from blade.

USING THE OPTIONAL WORK CLAMP

1. An optional work clamp (A) Fig. 10 is available. Use this

accessory clamp, especially with short workpieces. Never allow

your hands to be in the “Hazard Zone”.

2. Two holes (B) Fig. 9 are provided in the base of the miter saw,

enabling you to use the clamp (A) Fig.10 on either the right or

left hand side of the saw blade.

WARNING: Keep your hands out of path of saw blade. If

necessary, clamp the workpiece in place before making the cut

if hands would be within 6 in. of the blade.

STARTING AND STOPPING THE MITER SAW

To start the miter saw, depress the switch trigger (A) Fig. 11 To stop

the miter saw, release the switch trigger.

This saw is equipped with an automatic electric blade brake. As

ASSEMBLY TOOLS REQUIRED

(Supplied) * 5mm hex wrench * 1/2 in. Blade wrench

(Not supplied) * Phillips head screw driver * A square to make

adjustments

WARNING: For your own safety, do not connect the

machine to the power source until the machine is

completely assembled and you read and understand the

entire instruction manual.

WARNING: DISCONNECT MACHINE FROM POWER

SOURCE!

ATTACHING THE TABLE LOCK HANDLE

Thread the table lock handle (A) Fig. 2 into the threaded hole (B) of

the arm bracket.

ROTATING THE TABLE TO THE 90° DEGREE POSITION

1. Turn the table lock handle (A) Fig. 3 counter-clockwise one or

two turns, and depress the index lever (B) to release the 45°

positive stop.

2. Rotate the table to the left until the index stop engages with the

90° positive stop (Fig. 4). Tighten the table lock handle (A).

MOVING CUTTINGHEAD TO THE UP POSITION

1. Push down on handle (A), Inset, Fig. 5. Pull out the cuttinghead

lock pin (B).

2. Move the cuttinghead (C) to the up position (Fig. 6).

ATTACHING THE DUST BAG

Squeeze the spring clips (A) Fig. 7 of the dust bag (B) and clip the

dust bag (B) over the ribs of the dust chute.

ASSEMBLY

OPERATION

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 88 89

Comments to this Manuals

No comments

Black & Decker Fire Storm 90524442 Instruction Manual Page 30

Comments to this Manuals

Related products and manuals for Mitre saws Black & Decker Fire Storm 90524442