Black & Decker Fire Storm FS200SD Instruction Manual download pdf (Page 10)

ATTACHING MITER GAUGE HOLDER

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Fig. 9

1. Attach the spring clip (E) Fig. 5 to the miter gauge holder (A) using an M4x.7x10mm pan head screw (F), 3/16"

external tooth lockwasher, (B) and M4x.7 hex nut.

NOTE: The hex nut (G) Fig. 6 will fit into the recess at the back of the miter gauge holder (A) Fig. 5 to keep the

spring clip (E) secured to the miter gauge holder.

2. Attach the miter gauge holder (A) Fig. 7 to the left side of the saw cabinet using the four M4x.2x10mm screws (B)

Fig. 8, and 3/16" flat washers (C) from inside of the saw cabinet.

3. Fig. 9 illustrates the miter gauge (D) inserted into the holder.

Fig. 10

MITER GAUGE

The miter gauge is shipped assembled and is supplied with a T-slot bar (A) Fig. 10 that is inserted into either one of the

two T-slotted miter gauge grooves (B) located in the table top. The T-slot prevents the miter gauge from falling when it

is extended beyond the front of the table when cross-cutting extra wide workpieces.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Black & Decker Fire Storm FS200SD Instruction Manual Page 10