Black & Decker GSN35 Instruction Manual download pdf (Page 4)

Features

1. On/off switch

2. Lock-off button

3. Blade release button

4. Grass Shear blade (GSL35,

GSL75, GSN30, GSN35)

5. Shrub Trim blade (GSL35,

GSL75, GSN32, GSN35)

6. Blade cover (not shown)

Assembly

WARN ING:Avoidaccidentally switching thetoolon

during assembly,

Fitting and removing the

blade (fig. A, B, C)

The shear blade (4) has been

designed for trimming grass and

weeds. The trim blade (5) has been

designed for trimming hedges and

shrubs.

• To remove the blade cover (6).

Push and hold the blade release

button (3) in the direction of the

arrow (fig. A)

• Slide the blade cover (6)

backwards and lift it off (fig. A-l).

• While holding the blade onto the

pins (Fig. B), locate the blade cover

(6) and slide it forward (fig. C).

Note: No alignmentof blade with drive

pin isrequired and operation of the blade !,_ -2_

cover release button isnot requiredwhen (_6

re-fittingthe bladecover. ........

Charging Procedure

The baffery needs to be charged before

firstuse and whenever itfails to produce

suffident power on jobs thatwere easily

done before.When charging the battery

forthe firsttime, or afterprolonged

storage,itwill onlyaccept an 80%

charge. Afterseveral charge and discharge cycles, the battery willattain full

capacity.The battery maybecome warm while charging; this is normal and

does not indicate a problem.

/t,

WARNING: Do not charge the battery at ambient

temperatures below 36° F (2°C) or above 104°F (40°C).

Recommended charging temperature: Approximately 75°F (24°C).

• Note: Thecharger plug incorporateslock outs to prevent the use ofincorrect

chargers.The plugmust becorrectlyoriented when inserted.

• Insert the charger plug into the charger connector at the rear of the

tool (fig. D).

• Plug the charger into a 120V outlet. __ ...........................f--

Charge the tool for 16 hours before first use.

For catalog numbers GSL35, GSL75:

The charger indicator light will come on

indicating that the tool is charging. -............"-,

When the charge is complete the lightwillgo out.

For catalog numbers GSN30, GSN32, GSN35: _i_

The charger indicatorlightwill come on indicating _

that the tool ischarging.

The light will stay on as long as the charger is connected to the

tool and pluggedinto a working outlet.

ItWILL NOTflash, or go outwhen the chargingcycle iscomplete. To

maximizethe lifetimeof the battery,itis recommended to keepthe battery

connectedto the chargerwhenever the toolis not inuse. When the battery is

full, the power consumption of the charger is negligible.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Black & Decker GSN35 Instruction Manual Page 4

Comments to this Manuals

Related products and manuals for Power tools Black & Decker GSN35