Black-decker 9013 User Manual download pdf (Page 4)

Additional Drill

Safety Rules

1. Be aware that this tool is always in

an operating condition, because it

does not have to be plugged into an

electrical outlet.

2. When drilling or driving screws into

walls, floors or wherever "live"

electrical wires may be encountered,

DO NOT TOUCH ANY FRONT

METAL PARTS OF THE TOOL!

Hold the tool only by the plastic

handle to prevent electric shock if

you drill or drive into a "live" wire.

Important Charger & Drill

Safety Instructions

1. SAVE THESE INSTRUCTIONS -

This manual contains important

safety and operating instructions.

2. Before using battery charger, read

all instructions and cautionary

markings on battery charger and

drill.

3. The charger and drill are specifically

designed to work together. DO NOT

attempt to charge any other cordless

tool or battery pack with this

charger. DO NOT attempt to charge

the drill with any other charger than

the one supplied with the tool.

4. Do not expose charger to rain or

snow.

5. The battery charger is not intended

for any uses other than charging tbe

product shown in this manual. Other

uses may result in risk of fire or

electric shock.

6. To reduce the risk of damage to

electric plug and cord, pull by plug

rather than cord when disconnecting

charger.

7. Make sure cord is located so that it

will not be stepped on, tripped over,

or otherwise subjected to damage or

stress.

8. An extension cord should not be

used unless absolutely necessary.

Use of improper extension cord

could result in risk of fire and electric

shock. If extension cord must be

used, make sure:

a. That pins on plug of extension

cord are the same number, size,

and shape as those of plug on

charger;

b. That extension cord is properly

wired and in good electrical condi

tion; and

c. That wire is large enough for AC

ampere rating of charger as

specified in Table 1 (see Table

that follows).

9. Do not operate charger with

damaged cord or plug - replace

them immediately.

10. Do not operate charger if it has re

ceived a sharp blow, been dropped,

or otherwise damaged in any way;

take it to a qualified Black & Decker

Service Center.

11. Do not disassemble charger; take it

to a qualified Black & Decker

Service Center when service or

repair is required. Incorrect

reassembly may result in risk of

electric shock or fire. There are no

consumer serviceable parts inside.

12. To reduce risk of electric shock, un

plug charger from outlet before

cleaning.

13. NEVER attempt to connect 2

chargers together.

14. DO NOT store the tool in locations

where the temperature may reach or

exceed 120°F (such as outside

sheds or metal buildings in

summer).

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments