Black & Decker FIRESTORM FS210LS Instruction Manual download pdf (Page 13)

BLADE GUARD AND

SPLITTER ASSEMBLY

DISCONNECT MACHINE FROM

POWER SOURCE.

1. IMPORTANT: THE BLADE GUARD AND SPLITTER

ASSEMBLY MUST BE PROPERLY ALIGNED TO THE

SAW BLADE IN ORDER TO PREVENT KICKBACK.

2. Position the blade 90 degrees to the table and lock in

place. Refer to page 18 “Blade Raising and Lowering

Control” and page 19 “Blade Tilting Control”.

3. Fasten the splitter support bracket (A) Fig. 14, to

splitter bracket (B) using two 1/4-20 x 1/2 in. Hex Head

Screws (C), and two 1/4 in. external tooth lockwashers

as shown. NOTE: Do not completely tighten screws

4. Locate the 1/4-20 x 2-1/4 in. hex head screw (G) Fig.

15, and assemble the 1/4 in. internal tooth lockwasher

(O), 1/4 in. flat washer (P) and 1/4 in. external tooth

lockwasher (R) onto screw (G).

5. Position recessed end (E) Fig. 16, of splitter bracket

(B) against end of pivot rod (F) and fasten in place using

assembly from STEP 4 above. NOTE: Do not

completely tighten screw (G) at this time. Assembly

shown in Fig. 17.

6. Position the splitter (H) Fig. 18, on the splitter support

bracket as shown, making certain the two protrusions

(K) on the splitter support bracket are inside the slot of

splitter (H).

Fig. 14

Fig. 15

Fig. 16

Fig. 18Fig. 17

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

No comments

Black & Decker FIRESTORM FS210LS Instruction Manual Page 13