13
Service inforMation
All BLACK+DECKER Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power tool
service. Whether you need technical advice, repair, or genuine factory
replacement parts, contact the BLACK+DECKER location nearest
you. To find your local service location, call: 1-800-544-6986 or visit
www.blackanddecker.com
ProBLeM
Tool runs slowly.
Automatic line feed does not
feed more line.
SoLution
•Removebatteryfromtool.
•Checkthatthespoolhousing
can rotate freely. Carefully clean
it if necessary.
•Checkthatthecuttingline
does not protrude more than
approximately 4-13/16inches
(122mm) from the spool.
If it does, cut it off so that it just
reaches the line trimmingblade.
•Morelineisfedwhentheline
shortens to approximately 3
inches(76.2mm).Todetermine
if the line is not feeding, let line
wear past this point.
ProBLeM
Automatic line feed does not
feed more line.
SoLution
•Keepthetabsdepressedand
remove the spool from the spool
housing in the trimmer head.
•Ensurethatthelineisnot
crisscrossed on the spool as
detailed in figure U. If it is,
unwind the cutting line, then
wind it back on the spool neatly
so that the lines do not cross.
•Inspecttracksatthebottomof
spool for damage. If damaged,
replace spool.
•Readthecodeonthebackof
spool. If it reads “PA66” call
customer service for a replacement.
If it reads “ABS” this is not the issue.
•Pullthecuttinglineuntilit
protrudes approximately 4-13/16
inches (122mm) from the spool. If
insufficient cutting line is left on the
spool, install a new spool of cutting
line.
•Alignthetabsonthespoolcap
with the cut outs in the housing.
•Pushthespoolcapontothehousing
until it snaps securely into place.
•Ifthecuttinglineprotrudes
beyond the trimming blade, cut
it off so that it just reaches the blade.
If the automatic line feed still does
not work or the spool is jammed, try
the following suggestions:
•Carefullycleanthespooland
housing.
•Removethespoolandcheckifthe
lever in the spool housing can
move freely.
trouBLe Shooting guiDe
Comments to this Manuals