Black & Decker MM875 Instruction Manual download pdf (Page 3)

ASSEMBLING THE GRASSBAG (FIGURE 3A,3B,3C,3D)

1. UNPLUG MOWER, AND WAIT FOR BLADE TO COME TO A COMPLETE STOP.

2. Before starting to assemble the grassbag to the frame, check that the grassbag

and frame are similar to figure 3A.

3. Slide the grassbag onto the frame as shown in figure 3B.

4. Assemble the top clips to the frame as shown in figure 3C, then assemble the

two side clips and the bottom clip last.

5. Completely assembled grasscatcher see figure 3D.

MULCHING

The mower is designed to mulch or bag the grass depending on whether mulch

insert is in (mulching) or the mulch insert is out and the grass catcher is in place

(bagging). No further assembly steps are required if you are mulching.

PROCEED TO OPERATING INSTRUCTIONS.

GRASS CATCHER INSTALLATION (FIGURE 4A,4B,4C)

(If you wish to bag the clippings rather than mulch, perform

these steps)

1. UNPLUG MOWER, AND WAIT FOR BLADE TO COME TO A COMPLETE STOP.

2 Raise the rear discharge door and hold it up as shown in Figure 4A.

3 Locate your hand in the handle pocket as shown in Figure 4A, lift and pull out the mulch

insert completely.

4. Pick up the grass catcher by the handle and lower the grass catcher between the lawnmower

handles as shown in Figure 4B. Position the grass catcher hanger hooks on the lawnmower

as shown in Figure 4C. The rear discharge door is spring loaded. When you release it the

door will rest against top of bag assembly.

Warning: Never operate the mower unless the hanger hooks on the grass catcher are

seated properly on the lawnmower and the rear discharge door rests firmly

against the top of the grass catcher.

• DO NOT operate the lawnmower when barefoot or wearing open sandals.

• NEVER attempt to make a wheel height adjustment while the motor is running or

while the lawnmower is plugged in.

• DO NOT put hands or feet near or under rotating parts. Keep clear of the

discharge opening at all times.

• RELEASE switch lever to turn mower off when crossing gravel drives, walks, roads,

or when flipping handle.

• IF MOWER stalls, release switch lever to turn mower off, wait for blade to stop and

unplug the cord before attempting to unclog the chute or remove anything from

under the deck.

• AFTER STRIKING a foreign object, release switch lever to turn mower off, wait for

the blade to stop and unplug the mower, thoroughly inspect the mower for any

damage, and repair the damage before restarting and operating the mower.

• IF THE lawnmower should start to vibrate abnormally release switch lever wait for

blade to stop and unplug mower, check immediately for cause. Vibration is

generally a warning of trouble.

• RELEASE SWITCH lever to turn mower off, wait for the blade to stop and unplug

the mower whenever you leave the equipment, before removing the grass catcher,

discharge chute or unclogging or cleaning the mower housing, and when making

any repairs or inspections.

• MOW ACROSS the face of slopes; never up and down. Exercise extreme caution

when changing direction on slopes. Do not mow excessively steep slopes.

• KEEP HANDS and feet away from cutting area.

• KEEP BLADES sharp.

• IF YOU are using a grass catcher, check it frequently for wear and deterioration. If

excessively worn, replace with new bag for your safety.

• USE EXTREME CAUTION when reversing or pulling mower toward you.

SAVE THESE INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

BEFORE ASSEMBLING YOUR MOWER, CHECK THAT YOU HAVE RECEIVED THE

FOLLOWING IN THE SHIPPING CARTON. SEE FIGURE 1.

A. Mower

B. Upper Handle

C. Lower Handle

D. Mulch Insert (inside mower under rear door)

E. Grassbag and Grassbag Frame

UNPACKING THE MOWER

1. Your mower carton contains the mower, 2 handles (attached), mulch insert and

a grass bag and frame assembly.

2. Your mower has been completely assembled at the factory except for the grass

bag. Remove the grassbag, grassbag frame, mower and fillers from the carton.

UNFOLDING AND ADJUSTING THE HANDLE (FIGURE 2)

1. UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE STOP.

2. Raise the handle section into place and secure by tightening the two knobs.

Take care not to pinch or damage the power cord while adjusting the handles.

3. There are three holes on the upper handle, this allows the handle height to be

set in three positions. Choose the hole that best suits your overall height.

Install the bolts to the inside of the handles so that the knobs are on the

outside (to avoid interference with the rear door and grassbag). Tighten the

knobs securely.

KNOBS

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Black & Decker MM875 Instruction Manual Page 3

Comments to this Manuals

Related products and manuals for Grass trimmers Black & Decker MM875