Black-decker CO100B User Manual download pdf (Page 4)

2. With cabinet doors open, place mounting template flush against the surface of

the underside of your cabinet, making sure to align thick line on template with

bottom front edge of your cabinet (D).

Important:Donotalignscrewholesontemplatewiththepartitionbetween

cabinets,asthiswillpreventyoufrominstallingtheapplianceproperly.Pay

closeattentiontowherethedrillholeswillbesetsoasnottodamageyour

cabinetsduringmounting.Drillingthroughyourcabinet’spartitionmaycause

damagetocabinetsandpreventproperinstallation.

3. Once thick line is straight with bottom front edge, pull template tight and tape

down on all 4 corners to hold in place.

4. Drilling from under the cabinet up, drill holes through the 4 places marked on

the template, using a ¼-inch drill bit (E).

Important:Alwaysensureyouaredrillingstraightupthroughthemarked

mountingholeonthetemplate.Drillingatananglemaypreventproper

installationandmaydamagecabinetsifthedrillbitpiercesthepartition.

5. Once holes are drilled, remove tape and mounting template and save template

with your instructions in case you move or wish to remount at a later time.

6. Wipe dust and debris off inside cabinet surface. Also, make sure under side of

cabinet is clean.

7. Place a washer inside the cabinet over each of the 4 holes you drilled.

8. Hold appliance in place, aligning front of unit with front edge of cabinet;

drilled holes on cabinet should be aligned with mounting holes on the unit.

9. Screwing from inside the cabinet down into appliance holes, tighten 4 screws

in place to secure appliance to cabinet.

Note: Always tighten screws to ensure the appliance does not move or shake

during operation.

10. Pull out cord from cord storage behind appliance and plug into standard

electrical outlet. Extra cord can be fed back into storage or hung over cord

management hook behind unit (F).

Note: If connecting multiple †SpaceMaker™ appliances together, plug any

2-prong appliance into female receptacle at the rear of any 3-prong appliance.

11. Your †SpaceMaker™ appliance is now ready for use!

SPACERMOUNTINGINSTALLATION(OVERHANGLIPCABINETS)

Important:Alwayswearprotectiveglassesorgogglestopreventinjurywhen

drilling.

Note:Spacers are provided in case your cabinet has an overhang lip at the front

edge. The spacers are used on the rear screw holes of the appliance to ensure it is

level with the front. Only use spacers if your cabinet has an overhang.

1. Clear countertop under installation area to avoid getting dust or debris on other

appliances or items. Open cabinets and remove contents to make mounting

easier.

2. Using a ruler, measure the thickness of the overhang lip from the front to back

of the overhang, accurately noting the number for use in the following step (G).

Note: If you do not have a ruler, you may cut out and use the paper ruler provided

on the edge of your mounting template.

3. Once you have the overhang thickness, look at the dashed lines on the

mounting template; each line has a measurement next to it that indicates

the height of the lip used with that line. For example, if your cabinet has an

overhang thickness of ½”, you will use the ½” dashed line on the template.

4. With cabinet doors open, place line selected on mounting template even with

the bottom front edge of your cabinet, and tape in place against the lip (H).

1 2 3 4 5 6 7 8 9 ... 14 15

Comments to this Manuals

No comments

Black-decker CO100B User Manual Page 4

Comments to this Manuals

Related products and manuals for Knives Black-decker CO100B