Black-decker CO100B User Manual download pdf (Page 5)

5. With the paper securely taped in place against the lip, fold the rest of the

mounting template back against the underside of cabinet surface, bending

it to remain flush against both the back of the lip and the underside of the

cabinet (J).

Important:Donotalignscrewholesontemplatewiththepartitionbetween

cabinets,asthiswillpreventyoufrominstallingtheapplianceproperly.Payclose

attentiontowherethedrillholeswillbesetsoasnottodamageyourcabinets

duringmounting.Drillingthroughyourcabinet’spartitionmaycausedamageto

cabinetsandpreventproperinstallation.

6. Drilling from under the cabinet up, drill holes through the 4 places marked on

the template using a ¼-inch drill bit (seeillustrationE).

Important:Alwaysensureyouaredrillingstraightupthroughthemarked

mountingholeonthetemplate.Drillingatananglemaypreventproper

installationandmaydamagecabinetsifthedrillbitpiercesthepartition.

7. Once holes are drilled, remove tape and mounting template and save

template with your instructions in case you move or wish to remount

at a later time.

8. Wipe dust and debris off inside cabinet surface. Also, make sure under

side of cabinet is clean.

9. Place a washer inside the cabinet over each of the 4 holes you drilled.

10. Now, use your ruler or the paper ruler provided to measure the overhang

height, placing your ruler vertically against the underside of the cabinet

behind the overhang. This number determines the number of spacers you

need, using a number of spacers equal to the overhang height.

For example, a 1” overhang would use 2, ½” spacers on each of the

holes(K).

11. Place a washer inside the cabinet over each of the 4 holes you drilled.

12. Drop one of your screws through each of the washers covering the holes

in the cabinet, from inside the cabinet down.

13. Place the appropriate number of spacers determined in step 9 on each screw

to ensure the appliance will be even (L).

Note: For spacer installation, you may require assistance in mounting in order to

hold spacers in place while securing the appliance at the same time. If assistance

is not available, use a small clamp to hold the spacers in place while you position

the appliance.

14. Once spacers are set, hold appliance up and tighten screws to secure. Screw

from inside the cabinet down.

Note: Always tighten screws to ensure the appliance does not move or shake

during operation.

15. Pull out cord from cord storage behind appliance and plug into standard

electrical outlet. Extra cord can be fed back into storage or hung over cord

management hook behind unit (seeillustrationF).

Note: If connecting multiple †SpaceMaker™ appliances together, plug any

2-prong appliance into female receptacle at the rear of any 3-prong appliance.

16. Your †SpaceMaker™ appliance is now ready for use!

HowtoUse

This appliance is for household use only.

OPENINGACAN

1. Lift piercing lever.

2. Tip can so that the rim is under the locating post, then push down on the piercing

lever, making sure the cutter blade is inside the rim of the can (M).

Note:Because of the hands-free feature, it is not necessary to hold the lever down

or hold the can during cutting. However, you may have to support very tall or heavy

cans.

Tip: When the can is opened, the can opener will stop automatically.

1 2 3 4 5 6 7 8 9 10 ... 14 15

Comments to this Manuals

No comments

Black-decker CO100B User Manual Page 5

Comments to this Manuals

Related products and manuals for Knives Black-decker CO100B