Black & Decker NPT318 User Manual download pdf (Page 3)

DANGER: RISK OF CUT. Keep hands away from blades. Keep

both hands on handles when Pole Trimmer is on.

• DO NOT ATTEMPT to remove cut material or hold material to be

cut when blades are moving. Disconnect battery when clearing

jammed material from blades. Do not grasp the exposed cutting

blades or cutting edges when picking up or holding the Pole

Trimmer.

CAUTION: Blades coast after turn off.

• DON’T FORCE POLE TRIMMER - It will do the job better and with

less likelihood of a risk of injury at the rate for which it was

designed.

• DISCONNECT BATTERY from the Pole Trimmer when not in use

or when servicing or cleaning.

• STORE IDLE POLE TRIMMER INDOORS - When not in use, Pole

Trimmer should be stored indoors in a dry and high or locked-up

place out of reach of children.

• MAINTAIN POLE TRIMMER WITH CARE - Keep cutting blades

sharp and clean for best performance and to reduce the risk of

injury. Keep handles dry, clean and free from oil and grease.

• CHECK DAMAGED PARTS - Before further use of the Pole

Trimmer, a guard or other part that is damaged should be carefully

checked to determine that it will operate properly and perform its

intended function. Check for alignment of moving parts, binding of

moving parts, breakage of parts, mounting and any other condition

that may affect its operation. A guard or other part that is damaged

should be properly repaired or replaced by an authorized service

center unless otherwise indicated elsewhere in this manual.

Service

• Tool service must be performed only by qualified repair

personnel. Service or maintenance performed by unqualified

personnel could result in a risk of injury. See “Service Information”.

• When servicing a tool, use only identical replacement parts.

Follow instructions in the Maintenance section of this manual.

Use of unauthorized parts or failure to follow Maintenance

Instructions may create a risk of electric shock or injury.

Specific Safety Rules

• Hold tool by insulated gripping surfaces when performing an

operation where the cutting tool may contact hidden wiring or

its own cord. Contact with a "live" wire will make exposed metal

parts of the tool "live" and shock the operator.

WARNING: Some dust created by this product contains

chemicals known to the State of California to cause cancer, birth

defects or other reproductive harm. Some examples of these

chemicals are:

• compounds in fertilizers

• compounds in insecticides, herbicides and pesticides

• arsenic and chromium from chemically treated lumber

To reduce your exposure to these chemicals, wear approved safety

equipment such as dust masks that are specially designed to filter

out microscopic particles.

The label on your tool may include the following symbols.

V................volts A ....................amperes

Hz..............hertz W ..................watts

min ............minutes ..................alternating current

..........direct current

o ..................no load speed

..............

Class II Construction

....................earthing terminal

............safety alert symbol .../min ............strokes

per minute

SAVE THESE INSTRUCTIONS

1 2 3 4 5 6 7 8 ... 32 33

Comments to this Manuals

No comments

Black & Decker NPT318 User Manual Page 3

Comments to this Manuals

Related products and manuals for Power tools Black & Decker NPT318