Black & Decker FSMH1621 Service Manual download pdf (Page 9)

ENGLISH

(Original instructions)

select the correct operating mode for your particular cleaning

operation.

Using Autoselect

, choose from one of the following applica-

tions by pressing the autoselect button (6) until the required

setting is selected:

Wood/Laminate

Stone/Marble

Tiles/Vinyl

The steam mop will select the correct volume of steam

required for your particular cleaning operation.

Note: Always check you are using the correct setting before

using your steam mop. For convienience the steam mop will

remember the last setting you chose.

Steam burst (Fig. J)

The steam mop is equipped with a steam bust button to aid in

the removal of stubborn marks and stains.

u During use, press the steam bust button (28) to apply

extra cleaning power.

Note: The steam burst will last for 10 seconds then the steam

mop will return to the chosen setting.

Switching on and off (Hand held steam cleaner)

(Fig. K)

u To switch the appliance on, press the ON/OFF button (1).

It takes approximately 15 seconds for the hand held steam

cleaner to heat up.

Note: When the hand held steam cleaner is rst turned on

the water reservoir will glow red. Once the hand held steam

cleaner is ready to use the water reservoir will glow blue.

u Lift the lock off switch (2) and pull the trigger switch (3).

After a few seconds steam will be produced.

u To switch the appliance off, release the trigger switch (3)

then press the ON/OFF button (1).

Caution! Always empty the hand held steam cleaner after

use.

Caution! Steam may continue to be produced for a short time

after the trigger switch (3) is released, this is normal. Switch

off and allow the unit to cool before removing any accessories.

Hints for optimum use

General

Caution! Never use the steam mop without rst attaching a

cleaning pad.

u During steam mop use you can use the cable mamage-

ment clip (29) to keep your cable out of the way of the

work area..

u Always vacuum or sweep the oor before using the steam

mop.

u The easiest way to use the machine is to tilt the handle to

a 45˚ angle and clean slowly, covering a small area at a

time.

u Do not use chemical cleaners with your steam mop. To

remove stubborn stains from vinyl or linoleum oors, you

can use the steam burst button to apply extra steam to

the area or pre-treat with a mild detergent and some water

before using the steam mop.

Steam cleaning with the mop

u Fit hand held steam cleaner (5) to the steam mop body

(9).

u Place a cleaning pad (12) on the oor with the ‘hook &

loop’ side facing up.

u Raise the steam mop off the resting mat (13) and lightly

press it down onto the cleaning pad (12).

u Place the steam mop on the resting mat.

u Connect the steam mop to the mains.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Press the Autoselect

button (6) till the required setting is

reached.

u Pulling the handle (10) back will activate the steam pump.

After a few seconds steam will start to come out of the

steam head.

u It takes a few seconds for steam to enter the cleaning pad.

The steam mop will now glide easily over the surface to be

sanitised/cleaned.

u Push and pull the steam mop slowly across the oor to

thoroughly steam clean each section.

Note: During use you may turn off the steam pump by return-

ing the handle to the upright position, this convenient feature

will allow you to place the steam mop on the resting mat for

a short time so that you may move items of furniture, then

continue cleaning without the need to switch the appliance off.

u When you have nished using the steam mop, return the

handle (10) to the upright position and turn it ‘OFF’, place

it on the resting mat (13) and wait until the steam mop

cools down. (approximately ve minutes)

Caution! It is important to monitor the water level in the water

tank. To rell the water tank and continue to sanitise/clean, re-

turn the handle (10) to the upright position and turn the steam

mop ‘OFF’. Unplug the unit from the electrical wall outlet, rell

the water tank (8).

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop on

the resting mat (13) with the handle (10) in the upright position

when stationary and make sure the steam mop is turned off

when not in use.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments

Black & Decker FSMH1621 Service Manual Page 9

Comments to this Manuals

Related products and manuals for Steam cleaners Black & Decker FSMH1621