Black & Decker GH710 Instruction Manual download pdf (Page 10)

CAUTION: Before you begin trimming, only use the

appropriate type of cutting line. Ensure that cutting line is present in

both sections of the spool (figure M).

MAINTENANCE

WARNING: To avoid serious injury, switch off and unplug the

tool before performing any maintenance.

1. Keepthe air intake slotsclean to avoidoverheating.

2. Your trimmerlinecan dryout over time.Tokeepyourlineintop condition,

storespare pre-woundspoolsorbulkline ina plastic, sealable bagwitha

tablespoon of water.

3. Plastic partsmay becleanedbyusing a mild soap anda damprag.

4. The line cutter on the edge of theguard can dull over time.Itisrecommended

youperiodicallytouch-up the sharpnessofthe bladewitha file.

IMPORTANT: To assure product SAFETY and RELIABILITY,

repairs, maintenance and adjustment should be performed by

authorized service centers or other qualified service organizations,

always using identical replacement parts.

just reach the blade (figure M).

REWINDING SPOOLIF LINE UNRAVELS

(USE ONLY .065 IN. ROUND DIAMETER

LINE) (FIGURES O & P)

NOTE: Hand wound spools are likely to

become tangled more frequently than Black

& Decker factory wound spools. For best

results, factory wound spools are

recommended.

To rewind spools, follow the steps below:

• Unplug the tool.

• Remove the empty spool from the tool

as described in “REPLACINGTHESPOOL”.

• First wind new line onto the uppermost part of

the spool.

• Feed 3/4 inch (19mm) of

cutting line into one of the line

anchoring slots.

• Wind the cutting line onto

the spool in the direction of

the arrow on the spool. Make

sure to wind the line on

neatly and in layers. Do not

crisscross (figure O).

• When the wound cutting

line reaches the recesses (j),

cut the line. (figure P).

• Temporarily park the line in

the holding slots (k) on one side

of the spool as shown in the

inset in figure P.

• Repeat the above

procedure for the second

cutting line on the lower section of the spool.

• Fit the spool onto the tool as described in “REPLACING THE SPOOL”.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

Black & Decker GH710 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Grass trimmers Black & Decker GH710